User Manual

SETUP

H. Raising the tower as follows:

1) Remove the tower travel locking pin from the cradle at the rear of the cabinet.

2) Remove the tower locking pin from the tower base. Using the lower pivot winch, raise

the tower to the vertical position. Reinsert the tower locking pin into the tower base.

If there is any difficulty in tilting the boom verti-

cally, check the tailhook and hook. The tailhook

may need to be released. Release the tailhook by

pushing in on the crosshead assembly until the

tailhook is cleared from the hook angle.

BEWARE OF PINCH POINTS WHEN ERECTING

OR STOWING THE TELESCOPING TOWER. A

LOSS OF DIGITS OR LIMBS MAY RESULT FROM

UNSAFE PRACTICES.

Do not attempt to lean the tower down below 45

degrees when it is extended - serious damage

may occur.

WHEN RAISING THE BOOM, MAKE SURE THE

BOOM WIRING DOES NOT BECOME EN-

TANGLED.

Travel Locking Pin

Telescoping

Upper Winch

Rotational Lock

Kick-out Spring

Pivot Lower

Winch

Tower Locking