User Manual

SETUP

F. When applicable, drive grounding rod into earth. (Grounding rod not included)

1) Drive the rod into the ground and secure the grounding wire to the lug located on the

trailer frame.

Towing Chain

Tongue Jack

Outrigger Pin

Outrigger Jack

FIRM AND LEVEL AREA

Rear Jack

G. When applicable, install the floodlights on the crossarm.

1) Remove the light fixtures from their packing boxes and install them on the crossarm

with the lens facing the ground.

2) The cord on the fixture should be on the side closest to the trailer so the cord entry is

beneath the fixture when the tower is raised (this reduces moisture problems and

insures the water weep hole in the fixture is down).

3) Set the vertical aim for each light fixture by adjusting the light fixtures and tightening

the lower bolt.

4) Set the spread between the fixtures horizontally by adjusting the fixtures and tighten

ing the mounting nut.

5) The light fixtures may be left on the unit when towed around the job site. They can be

removed and stowed for highway towing.

6) Plug each fixture into the receptacles provided. Plug into the numbered receptacles in

a clockwise rotation starting at the upper or 1:00 o’clock position. This makes trouble

shooting easy without lowering the tower.

If Tungsten Halogen lamps are used, the cord

must be routed and secured away from the fix-

ture. Failure to do so may result in cord burn-

through and short circuit due to the high fixture

temperature.