User Manual

Software Installation and Update
35
6.0 Software Installation and Update
6.1 Software Installation and Configuration
6.1.1 Introduction
All system software is pre-loaded (see System Software Overview). You will, however,
need to configure the following components:
• The Administration Station (ADMS) Wi-Fi connection is configured for the IMS. See
Setting the Administration Station (ADMS) SSID to Connect to the Mobile Gateway
System (MGS).
• The IMS Personal Digital Assistant (PDA) needs to be configured for the customer.
You configure the PDA using the IMS Application Configuration Tool (ACT) which
resides on the ADMS laptop computer. See Configuring the IMS Application
.
• The Remote Sensor Nodes (RSNs) need to be set up with configurations. You create
configurations and download them to RSNs using the RSN Configuration Tool (RCT)
which resides on the TeraHop Console in the ADMS laptop computer. See
Configuring RSNs
.
• The CustomerID and First Responder bit are configured in the MMR. See How to
Edit CustomerID and AcceptFirstResponder Options in the MMR.
• Once the hardware is set up and the PDAs and RSNs have been configured, the entire
system needs to be tested and checked out. See Operational Checkout and System
Commissioning.
6.1.2 Intended Audience
This section is intended to outline the procedure to update the TeraHop Incident
Management System (IMS). It assumes the components are, at a minimum, loaded with
the factory base software image, the MMR pre-registered at TeraHop, and that the 4-digit
Area ID is known.