User Manual

Configuring the System
115
Motion
The Motion sensor is used to determine when an asset carrying an RSN is in motion for a
defined duration when it is not expected to be. The enabling of this sensor, reporting, its
sensitivity, along with the motion duration, are configurable under the Motion tab. The
Report Frequency is a setting that defines the amount of time (in seconds) that must pass
before a repeat event alarm is sent to the user application. It is recommended that this setting
remain at zero, which will issue an alarm for each event occurrence.
To configure the Motion sensor, do the following:
1. Click the Motion tab.
2. To enable Motion under this Behavior Profile, override and select the Enable Motion
Event check box.
3. In the same manner, override the Motion Sensitivity radio buttons selections.
4. Click to select the desired Sensitivity level radio button.
Note: it is recommended that the default sensitivity be selected until ample field
experience is obtained to justify a different sensitivity selection.