User's Manual

GC1000-03-00559 (REV. 01) PAGE 5 OF 7
Figure 3
STEP 4
If you are going to connect the Gateway to a Battery Pack, attach the female end
of the Battery Jumper Cable (J) to the Battery Input bulkhead fitting (see Figure
4) of the 1030/1040 Gateway (A) as shown in Figure 5.
STEP 5
If you are going to connect the Gateway to a 12 VDC Power Supply (H), attach
the female end of the Power Supply cable to the DC Input bulkhead fitting (see
Figure 4) of the 1030/1040 Gateway (A) as shown in Figure 5. Attach the IEC
C13 Power Cable (I) to the Power Supply.