User's Manual

GC1000-03-00559 (REV. 01) PAGE 4 OF 7
(B). Wrap another Tube Clamp (D) around the pole through the other set of
clamp holes in the Pole Mount (B). Tighten the screw on the Tube Clamps (D)
with the flat head screw driver to fasten the 1030/1040 Gateway (A) to the pole.
See Figure 2.
Figure 2
STEP 3
Attach the Flat Mount Bracket (E) to the back of the Pole Mount (B) as shown in
Figure 3. Position the assembled 1030/1040 Gateway (A), Pole Mount (B), and
Flat Mount Bracket (E) against the flat side of the square pole. Make sure that
the bulkhead fittings of the Gateway are facing downward (see Figure 3). Wrap a
Tube Clamp (D) around the pole through the clamp holes (labeled in Figure 3) in
the Pole Mount (B). Wrap another Tube Clamp (D) around the pole through the
other set of clamp holes in the Pole Mount (B). Tighten the screw on the Tube
Clamps (D) with the flat head screw driver to fasten the 1030/1040 Gateway (A)
to the pole.