User's Manual

GC1000-03-00559 (REV. 01) PAGE 3 OF 7
TOOLS NEEDED
- Flat head screwdriver
- Phillips head screwdriver
STEP 1
With the Phillips head screwdriver, assemble the Pole Mount (B) to the
1030/1040 Gateway (A) using the ¼”-20 screws (C). See Figure 1 below.
For mounting the Gateway to a round pole or to the corner of a square pole,
proceed to Step 2. For mounting the Gateway to the flat side of a square pole,
proceed to Step 3.
Figure 1
STEP 2
Position the assembled Pole Mount (B) and 1030/1040 Gateway (A) against the
round pole or corner of the square pole. Make sure that the bulkhead fittings of
the Gateway are facing downward (see Figure 2). Wrap a Tube Clamp (D)
around the pole through the clamp holes (labeled in Figure 2) in the Pole Mount