User Guide © 2014, Teradek, LLC. All rights reserved.
Contents Connect and Power ..........................................................................................2 Hardware description..................................................................................2 Front ...........................................................................................................2 Rear..............................................................................................................2 LED Operation .....................................
CONNECT AND POWER encoder cards. 4. Connect SD/HD-SDI outputs via BNC cable to your monitor/switcher/router. FRONT Connect to T-RAX T-RAX can be configured using its built-in web interface. This is accessible over your network, or via the built-in Wi-Fi. 1. Encoder/Decoder card slots 1-8 2. Controller card 3. Display 4. Display operation buttons 5. Power on/off button Ethernet defaults IP mode: DHCP, T-RAX will request an IP address from your network.
The network configuration page also shows statistics about the Ethernet interface, including up time, the MAC address, IP address, and the amount of data sent and received. The following configuration options are available. • Protocol – Select between DHCP client and Static address. When set to DHCP, T-RAX will request an IP address and all other network configuration from the network’s DHCP server.
Support Resources In addition to this Reference Guide, there are a number of resources available for more information on T-RAX’s features and operation. For online information, visit www.teradek.com. If you are unable to find what you need online, please contact Teradek’s support staff: E-mail: support@teradek.com | Phone: (888) 941-2111 ext. 2 (available M-F 7AM-6PM PST) Disclaimer This manual is intended for user information only.
