Quick Start Guide

Connect the motor(s) to the receiver using a 4-pin connector. If connecting two or more motors, use
a 4-pin to 4-pin connector to daisy-chain them together. The motor(s) will then begin calibrating.
2
3
Attach the motor(s) to the rods/lens.
Connect power to the receiver’s PWR port (N).
1
Insert an LP-E6 battery in the controller, then press the REC/PWR (B) button to turn on the controller.
4
Press the MENU button on the controller, then navigate to WIRELESS>FIND RECV to scan for active
receivers and automatically pair. The LED on the controller will turn green once paired.
Wireless Pairing
Connect a 5-pin connector from the controller’s wired-mode input (H) to the IN-1 input on the receiver.
The controller and receiver will remain paired even after disconnecting the 5-pin connector. The LEDs
on the controller and receiver will turn blue once paired.
Wired Pairing
3
PAIR CONTROLLER AND RECEIVER
POWER AND CONNECT
If the controller has not been paired to a receiver, you can use one of the following methods to pair
both devices: