User Manual

6. General Remarks

● If the sensor is disconnected/powered down, the BPTD or PD counters are

automatically reset.



● The parameter sliders present in the GUI are connected to each other. For            

instance, if you move the maximum range value for the Swipe Mode too close             

(<25 cm) to the minimum range threshold of the Engagement Trigger Mode, then            

this Engagement threshold will automatically increase to keep the minimum         

range interval required.



● Once a validation gesture has been detected, a left/right movement may be           

detected immediately after, if the person’s hand is properly aligned with the           

sensor. In this case, we suggest:

○ Increase the gap between the respective thresholds of the Validation and          

Swipe mode, in order to filter unwanted Swipe detection.

○ Set a timer of 0.5 seconds after a Validation event, in order to not             

acknowledge the following movement (hand exiting a validation status).



Terabee, 90 Rue Henri Fabre

01630, St Genis-Pouilly, France (next to CERN)



29/29