Product Specifications

Copyright©Terabee2016
1.3 Dimensions and Mounting
The TeraRanger One provides three mounting holes, which are designed for M2.5 screws.
The individual distances between the holes are shown in the following figure which is valid
for all designs of the yellow outer plastic part. Moreover, the
following aspects should be taken into consideration when
mountingtheTeraRangerOne:
Do not remove the plastic cover as this will misalign the
opticsanddegradethesensor’sperformance
MounttheTeraRangerOneinawellventilatedlocation
Take the usual precautions for sensitive electronics
such as maintaining a suitable distance to strong electric
and magnetic fields, strong radio emitters, strong heat
sources,etc.
1.4 About the Connector
The TeraRanger One connects to your equipment using a 15 pin connector of the Hirose
DF13 series. (The part number of the corresponding female connector is DF1315S1.25C.)
The cable assembly delivered with the TeraRanger One comes with six wires installed:
Ground (GND, pin 1 and 15), positive supply voltage (Vcc, pin 14), UART receive (RXD, pin
12)*, UART transmit (TXD, pin 13)* and reset (pin 7) . Please use the following image (valid
forallyellowouterpartdesigns)andtabletoidentifythepins:
Pin Function
15 GND
14 Vcc(10V,accepts1020V)
13 Serialout(TXD),5Vlevel
12 Serialin(RXD),5Vlevel
11 TWI**SDA
10 TWI**SCL
9 UserI/O1
8 UserI/O2
7 Arduinocompatibleresetin(toDTR)
6 Resetin(pulltoGNDtoreset)
5 MOSI(forSPIorflashing)
4 MISO(forSPIorflashing)
3 SCLK(forSPIorflashing)
2 +5Vout(useonlytoprovidevoltagelevelstoprogrammingdevices,max.10mA!)
1 GND
90 Rue Henri Fabre Website:
01630 St. Genis‐Pouilly Technical support:
France (next to CERN) Commercial:
www.teraranger.com
support@teraranger.com
teraranger@terabee.com
4