Terabee SAS TeraRanger Multiflex 8 Sensor Kit : Data Sheet : Page 8

installation, unplug the interface for a moment and plug it back in. The virtual COM port

should now be available on your PC.

Note: Do not plug and/or unplug the sensor units while the TeraRanger Multiflex is powered

by a computer. Disconnect the USB cable first!

1.9 NormalOperation

Each time the TeraRanger Multiflex Hub is powered, the GREEN LED will turn on. At the

same time, the Hub will detect how many sensors are connected. The ORANGE LED will

blink once for each sensor detected. It can take a few seconds before the distance values

become available on the UART, USB and/or I2C interfaces. Once available, a BLUE LED

will start blinking, indicating that the distances are being sent continuously to UART, USB

or I2C interfaces.

Figure 4. LED orientation on the TeraRanger Multiflex Hub



 



Terabee Website:

90RueHenriFabre Technicalsupport:

01630Saint-Genis-Pouilly Commercial:



www.teraranger.com

support@teraranger.com

teraranger@terabee.com



8