Data Sheet

Copyright © Terabee 2017
1.5 AbouttheConnector
The TeraRanger Multiflex Hub connects to your equipment using a 7-pin connector from
the Hirose DF13 series. (The part number of the corresponding female connector is
DF13-7S-1.25C.) The TeraRanger Multiflex does not ship with a connector cable, but we
recommend purchasing the female connector here. Please use Figure 3 and following table
to identify the pins:
Figure 3. TeraRanger Multiflex Hub
Pin Function
7 GND
6 RX Serial In (UART)
5 TX Serial out (UART)
4 Interrupt pin
3 SDA with pull up resistor (I2C)
2 SCL with pull up resistor (I2C)
1 5V
Important:
● Once connected, DF13 connectors are very reliable and are perfect for robotics and
drone environments where vibrations are common. These connectors are not,
however, designed for continuous plugging and unplugging. If you need to plug and
unplug the sensors frequently, consider adding a more suitable connector in-line.
● Please do not apply shear forces to the connector when pushing it in the socket.
Ideally, press the socket down to the PCB with your thumb and push the connector
in with your other hand. Do not use tools like pliers etc!
● Please follow basic rules on ESD safety when connecting and touching the
TeraRanger Multiflex or TeraRanger Multiflex Hub!

Terabee Website:
90RueHenriFabre Technicalsupport:
01630Saint-Genis-Pouilly Commercial:

www.teraranger.com
[e-mail]
[e-mail]


6