Data Sheet

Copyright © Terabee 2017
1.2 SafetyNote

Each TeraRanger Multiflex sensor contains a laser emitter and corresponding drive
circuitry. The laser output power must not be increased by any means and no optics should
be used with the intention of focusing the laser beam.
1.3 DimensionsandMounting
TeraRanger Multiflex sensors are enclosed with polycarbonate covers. For optimal
performance please make sure that the covers are touching the sensor’s PCB by
screwing the sensor units to a flat surface using M3 screws.
The TeraRanger Multiflex provides two mounting holes on both: (a) the TeraRanger
Multiflex Hub (Figure 1), and (b) the sensor units (Figure 2). Both pairs of mounting holes
are designed for M3 screws. The individual distances between the holes, and the sensor
external dimensions are illustrated in the two figures below.
Figure 1. TeraRanger Multiflex Hub dimensions in millimeters

Terabee Website:
90RueHenriFabre Technicalsupport:
01630Saint-Genis-Pouilly Commercial:

www.teraranger.com
[e-mail]
[e-mail]


4