Data Sheet

Copyright © Terabee 2017
2. sudo apt-get install cutecom
3. cutecom
The application automatically runs after launching the command “cutecom”. Next, enter the
corresponding Device name by sending the following command in your Linux shell
window:
ls /dev/tty*
The device name is usually /dev/tty/ACM0 or /dev/tty/ACM1.
Figure 19. Recognizing Device Name
In the main interface, make sure to fill the following fields (Baudrate, Data Bits, Parity, Stop
Bits) as shown in Figure 20.
Figure 20. Baudrate, Data Bits, Parity, Stop Bits
Click the “Open Device” button to start the data stream in millimeters. Note that distance
values are separated from each other via the character “\0x09”.
Should you see an error stating that the opening has failed then try sending the following
command directly from the linux shell window to grant access to the serial port.
sudo chmod a+rw /dev/ttyACM0

Terabee Website:
90RueHenriFabre Technicalsupport:
01630Saint-Genis-Pouilly Commercial:

www.teraranger.com
[e-mail]
[e-mail]


17