Data Sheet
Copyright © Terabee 2018
Connector type and name:
Pin
Designator
Description
1
5V
+5V supply output
2
RFU
Do not connect, reserved for future use
3
DOUT
Control data output to drive four WS2812B Leds
4
GND
Power supply and interface ground
Figure 7. WS2812B serial communication, pinout layout
5 Communication and Modes
The current Tower Evo firmware (1.1.1) provides four parameters for optimization of Tower
Evo performance. The following parameters can be configured:
1. Printout modes
2. Operating modes
3. Update rate modes
4. IMU modes
Figure 8 illustrates the logic of available parameters on Tower Evo. Please note all
commands to be sent via terminal emulation software are in hexadecimal format.
Terabee Website:
90 Rue Henri Fabre Technical support:
01630, Saint-Genis-Pouilly Commercial:
www.teraranger.com
support@teraranger.com
teraranger@terabee.com
15/27