Data Sheet

Copyright © Terabee 2018
Figure 5. UART for Hub Evo board
The UART for Hub Evo board uses a single 6 pin Hirose DF13 connector for interfacing to
the host system. The mating connector is a Hirose DF13-6S-1.25C with crimping contacts
DF13-2630SCF (tin) or DF13-2630SCFA (gold). Please consider the mechanical stability of
the mated connectors and avoid any kind of excess force on the connector (during
installation and once integrated) and follow the recommendations in the Hirose DF13 series
datasheet (available here: https://www.hirose.com/product/en/products/DF13) to ensure a
reliable connection.
The table below provides an overview of the pin out for the DF13 connector:
Pin out and description (According to DF13 datasheet)
Pin
Designator
Description
1
NC
Not Connected
2
Rx(in)
UART receive input. 3.3V logic
3
Tx(out)
UART transmit output. 3.3V logic
4
NC
Not Connected
5
NC
Not Connected
6
GND
Interface ground

Terabee Website:
90 Rue Henri Fabre Technical support:
01630, Saint-Genis-Pouilly Commercial:

www.teraranger.com
[e-mail]
[e-mail]
12/27