User's Manual
Table Of Contents
Manual KeyReader Plus
Manual
KeyReader Plus
TeraTron GmbH
Page 11 of 12
Document Version 1.0
Date: 19.07.2016
Autor: Frank Bajahr
Manual_KeyReaderPlus.doc
At the Configuration page the system time is shown. If there is an active connection to the Internet the
system time is set automatically. In case there is not Internet connection the system time can be set by
hitting the “Set System Time” button.
Identifier Key Reader Plus: name teh KeyReader Plus to your personal needs
Web-Interface IP-Port: Port for this web interface. Default port is 80
Use Old Operation Mode: If this is switched to On the KeyReader Plus will not send data to the KAI
Server. It is only possible to collect the key data via the mass storage feature.
Web Interface User Name: login name
Web Interface Password: login password
Duration Find Me: repetition of acoustic signal for “Find me” Featrure.
Wifi: Operation mode for Wifi interface. OFF, DHCP or static.
Wifi Security: Select Security Mode: WPA or IEC802.1X (Radius Server Mode)
Wifi SSID: SSID of the desired network
Wifi /Radius Password: network password (WPA or Radius password)
Wifi Radius User Name: user name of radius server
The following for IP-numbers only have to be selected manually if Wifi-mode „static“ was selected. In
this case please check with your network admin for correct settings.
USB Subnet: subnet for the USB connection. Please don´t change if you are not sure
USB IP: IP address for USB connection. Please don´t change if you are not sure
USB Gateway: IP address of USB host PC. Please don´t change if you are not sure
The following settings have to be adviced by your network admin
KAI IP Address: Adress of KAI Server
KAI Port: Port of KAI Server
KAI Path: Path of KAI Server
Any change has to be confirmed by teh Button „Save nd Reset. After a reboot the new settings are
valid.
5 Operation of KeyReader Plus
After the correct configuration the KeyReader Plus is able to operate. If you place a vehicle key pn top
of the landing pad the key is read and the data are send to the KAI Server.
The start of the reading is indicated by an acoustic beep and the yellow “Key” LED. During reading the
key should stay in the reading position. After the key is successfully read a second beep will indicate
this condition. In addition the “Key” LED will change to green.