Operating Manual

Desktop KeyReader Plus

Operating Manual

Desktop KeyReader Plus

©TeraTron GmbH

Page 8 of 12

Document Version 1.0

Date: February 25, 2021

Author: Marcel Mörchen

DesktopKeyReaderPlus_EN.docx

second confirmation signal sounds, and the LED light glows solid green for four seconds. (The upload

time depends on the key and the amount of data stored, and may vary by several seconds).

Due to the large number of supported key types, it is difficult to recommend a single, universal

procedure. As such, the scenarios illustrated are intended merely as a general guideline.

Data is transmitted exclusively via USB.

Other devices running on the same frequencies (125 kHz/13.56 MHz) may interfere with the upload

quality. Please ensure that no other devices with the same frequency as Desktop KeyReader Plus are

in the vicinity during operation. Please note that this applies in particular to other Desktop

KeyReader Plus devices.

We recommend placing devices at least one meter apart.

Monitors, laptop chargers and printers can also cause interference that can affect Desktop

KeyReader Plus’s reading performance.

5.2. Vehicle Key Data

Once Desktop KeyReader Plus issues the second confirmation (second beep and/or green LED), the

vehicle key data is sent to the connected PC and stored by the ITOOLS-USBTrayApp in the folder

specified.

For more information, please consult the ITOOLS-USBTrayApp manual.