Operating Manual

Desktop KeyReader Plus
Operating Manual
Operating Manual
Desktop KeyReader Plus
©TeraTron GmbH
Page 3 of 12
Document Version 1.0
Date: February 25, 2021
Author: Marcel Mörchen
DesktopKeyReaderPlus_EN.docx
1. Introduction
Desktop KeyReader Plus is a stationary device for reading out the vehicle data stored in the vehicle
key. Once successfully read, the data is transmitted to a USB-connected PC. From there, the data is
transmitted to a target system (KAI server).
The USB connection also ensures the power supply.
1.1. Setup
To run and configure Desktop KeyReader Plus on a PC, first install and launch the ITOOLS-
USBTrayApp software. This tool communicates with Desktop KeyReader Plus, receives read-out key
data, and sends configuration commands, e.g. to adjust the volume.
This communication begins as soon as Desktop KeyReader Plus is connected.
KAI server
Desktop KeyReader Plus
Desktop PC
USB
Figure 1: Typical system configuration
Desktop KeyReader Plus
Desktop PC
LAN/WLAN
KAI server
USB