User's Manual

Block diagram CAN Immobilizer Key-Plugin
Document no.
CAN Immobilizer Key-Plugin Block Diagram
Project
CAN Immobilizer Key-Plugin
Document for
FCC
Creation date: 26.07.2016
Revision
Generate
Approved
Confidentiality
Page
Document
1.0
MSC
RHE
Strictly
confidential
2 of 2
CAN Immobilizer Key-Plugin Block diagram.doc
Description of block diagram CAN Immobilizer Key-Plugin
The µP is clocked by a 8MHz-Resonator. The active components are powered by 5V from
a linear LDO regulator. The 125kHz-Reader drives the 125kHz coil antenna. By the switch
/ interface the electronic will be powered on. The data will be transmitted via the CAN-
interface.
CAUTION TO USERS
“Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.”
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.