User's Manual
13
3). Humidity requirements:
a) Install equipment in a dry environment to avoid moisture, dripping, water spray, etc. Do not install the device in a place where it may accumulate water
or a wet place where liquid will drip.
b) Do not touch the device with wet hands, or touch the device while standing in the water or in contact with other water sources, because there is a risk
of electric shock.
2. Installation
DVR Main device installation
1). In order to extend the life of the equipment, please install the equipment as far as possible in the part where the vehicle vibration is weak.
2). Device should be installed at the place with good ventilation: please keep the distance at least 6 inches(15 centimeters) away from other
device to facilitate the circulation and heat dissipation of the air; it shouldn’t be installed in the conned space(such as rear trunk of the vehicle).
3). The external wiring of the equipment should be adequately spaced and protected by a ame-retardant tube to ensure that the wire is not
bent or leaks due to vibration and wear.
4). Make sure that the device is away from the heat source on the vehicle. There should be no sundries around the device. It is strictly forbidden
to place any items on the device.
5). The equipment can only be installed horizontally or laterally (if there are installation requirements in other directions, please consult the
manufacturer rst). Any other angle of installation may damage the equipment and is strictly prohibited.
6). Insert sim card and TF card accurately as indicated on the device.