User Manual

.04.
INSTRUCTION MANUAL
•
To control the internal temperature, adjust the control knob according to the ambient
temperature or purpose of use.
•
The range of the temperature control is from position "0" to "3".

INSTRUCTION FOR USE
•
Position your refrigerator so that the plug is accessible.
•
Keep your refrigerator out of direct sunlight.
•
Do not place next to heat generating appliance.
•
Do not place directly on the ground. Provide suitable stand
IMPORTANT
•
The refrigerator will have better performance at ambient of 20-25 degree; We suggest
the refrigerator be powered off if the ambient temperature is lower than 10 degree.
•
After plugging the appliance, allow the unit to cool down for 2-3 hours before placing
beverage into the refrigerator compartment.
•
Ventilation is very important for this kind thermoelectric refrigerator; The inside
PCB will be broken easily if the ventilation is bad; It will also reduce the life of the
refrigerator.
•
The refrigerator applies automatic defrosting system, so there is no need to defrost it
manually.

POWER SUPPLY
•
The refrigerator must be connected to a properly earthed socket in line with relevant
valid country regulations before operating;
•
Check the data label (which is on the side of the refrigerator) for voltage and
frequency corresponds to your local one; If not, don't plug your cable into the socket;
INSTALLATION
When install a Heat pipe Refrigerator, ventilation should be considered seriously, please
refer to the following:
●
There should be left at least 200 cm³ for ventilation
●
he distance between wall and refrigerator side should be at least 20mm
●
The bottom should be left at least 50mm for air flowing air passing through must not
be preheated
●
Entire cooling system should be considered in the ventilation
●
The following four pictures show four installation ways: