User Manual

empower your supply chain.
V1.0-12/2021-DE · Technical Changes and Errors excepted 9
6. Operation and Usage
STEP 1 Conguration*optional
Thisstepisonlynecessaryifyouwanttoadaptthepre-installedcongurationtoyourapplication.
- Download the free tempbase 2 software – https://www.tempmate.com/de/download/
- Install the tempbase 2 software on your PC.
- Remove the cap and connect the not started logger to your PC.
- Open the tempbase 2 software and select the „Logger Setup“ button“ (1).
- Make the desired settings and save them via the „Save Parameter“ button (2).
- Remove the logger from your PC and replace the cap securely.
STEP 2 Start Logger
- Press and hold the green start button for 5 seconds.
- AsuccessfulstartisindicatedbythegreenLEDonyourdeviceashing10times.
- Note:Ifanotherornoashingsignalappears,donotusetheloggerandcontactsupport.
STEP 3 Set Mark
- Brieypressthegreenstartbuttontwiceinsuccessiontosetamark.
- A successfully set mark is indicated by the word „MARK“ and the number of marks set so
far in your display.
- Note: Up to 10 marks can be set per operation.
STEP 4 Stop Logger
- Press and hold the red stop button for 5 seconds.
- AsuccessfulstopisindicatedbytheredLEDonyourdeviceashing10times.
Alternative stop modes
Automatic Stop (default setting)
o The device will stop automatically when the maximum number of measured values in the
data memory is reached and no manual stop is performed beforehand.
o This stop mode works in addition to the manual stop.
Software Stop (optional)
o This setting can be made in the tempbase 2 software. (see STEP 1)
o The stop is triggered automatically by connecting the logger to the PC and opening
the software.
 o Amanualstopisnotpossibleinthisconguration.
STEP 5 Manual Readout of Data
- Remove the cap and connect the logger to your PC.
- AsuccessfulconnectionisindicatedbybothLEDsashing.TheabbreviationsCSVandPDFappear
one after the other in the display.
- The logger automatically opens as an external drive on your PC. This process may take a few minutes
depending on the amount of data.