User Manual

5
User Manual
For tempmate.®-M1 Data Logger
06. LCD display notice
Alarm LCD display
When LCD display time is configured to 15 s, click left key to activate the display. If over temperature incident occurs,
it firstly displays alarm interface for about 1 s, then skips to main interface automatically.
When display time is configured to “forever”, over temperature alarm occurs permanently. Press left key to skip to
main interface.
When display time is configured to “0”, there is no display available.
07. Appendix 1 – working status description
Device status LCD display Device status LCD display
1 Start logger 5 MARK success
2 Start delay
 is flashing
6 MARK failure
3 Recording status
During recording status, in
the middle of the first line,
static display 
7 Device stop
In the middle of the first
line, static display 
4 Pause
In the middle of the first
line, blinking display 
8 USB connection
08. Appendix 2 – other LCD display
Device status LCD display Device status LCD display
1 Erase data status
3 Alarm interface
Only exceed upper limit
2 PDF generation status
PDF file is under generation,
PDF is in flash status
Only exceed lower limit
Both upper and lower
limit occurs
i
tempmate GmbH
Germany
Wannenäckerstr. 41
74078 Heilbronn
T [phone]
F [phone]
[e-mail]
www.tempmate.com