User Manual

4
User Manual
For tempmate.®-M1 Data Logger
(3) During the tempmate.®-M1 is connected with the computer, the M1 is generating a PDF report depending on the
configuration:
• If tempmate.®-M1 is stopped, it always generates a report when the M1 is plugged in the USB port
• If tempmate.®-M1 is not stopped, it only generates a PDF when it is enabled in the “Logger Setup”
03.7 Multiple start
The tempmate.®-M1 supports the function of continuous starting after last logger stopping without the need to
reconfigure the parameters.
04. Key function description
Left key: Start (restart) tempmate.®-M1, menu switch, pause
Right key: MARK, manual stop
05. Battery management
05.1
Battery level indication
Battery level indication Battery capacity
40 % ~ 100 %
20 % ~ 40 %
5 % ~ 20 %
(flash)
< 5 %
Note:
When the battery capacity is lower or equal to 10%, please replace the battery immediately. If the battery capacity is
lower than 5%, the tempmate
.®-M1 will stop recording.
05.2 Battery replacement
Replacing steps:
Note:
It is recommended to check the battery status
before restarting the logger to ensure that
the remaining battery life could finish the
recording task. The battery can be replaced
before you configure the parameter. After
replacement of battery, the user needs to
configure the parameter again.
When the logger is connected to computer
under the status of recording or pause status,
it is prohibited to plug out the tempmate
.®-M1
without battery power supply.
i
tempmate GmbH
Germany
Wannenäckerstr. 41
74078 Heilbronn
T [phone]
F [phone]
[e-mail]
www.tempmate.com