Data Sheet

Integration instructions for host product manufacturers according to KDB
996369 D03 OEM Manual v01
2.2 List of applicable FCC rules
FCC Part 15.247&47 CFR FCC Part 15 Subpart E 15.407 &FCC CFR Title 47 Part 2, Part 22H
&FCC CFR Title 47 Part 2, Part 24E&FCC CFR Title 47 Part 2, Part 27
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter in a
host, host manufacturer have to consult with module manufacturer for the installation method in end
system.
2.4 Limited module procedures
Not applicable. The module is a Single module and complies with the requirement of FCC Part
15.212.
2.5 Trace antenna designs
Not applicable. The module has its own antenna, and doesn’t need a host’s printed board
microstriptrace antenna etc.
2.6 RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained between
the antenna and users’ body; and if RF exposure statement or module layout is changed, then the
host product manufacturer required to take responsibility of the module through a change in FCC ID
or new application. The FCC ID of the module cannot be used on the final product. In these
circumstances, the host manufacturer will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
2.7 Antennas
This radio transmitter
2AM5I-M101C
has been approved by Federal Communications Commission
to operate with the
antenna types listed below, with the maximum permissible gain indicated. Antenna types not
included in this list that have a
gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with
this device.
Model name
Antenna type
Antenna gain
M101C
PIFA Antenna
3.0 dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC
ID:2AM5I-M101C".
2.9 Information on test modes and additional testing requirements
Host manufacturer must perfom test of radiated & conducted emission and spurious emission, etc
according to the actual test modes for a stand-alone modular transmitter in a host, as well as for
multiple simultaneously transmitting modules or other transmitters in a host product. Only when all
the test results of test modes comply with FCC requirements, then the end product can be sold
legally.