Operation Manual

- 5 -
OPERATION ON THE BATTERY CHARGER.
2. INTRODUCTION AND GENERAL DESCRIPTION
- This battery charger can be used to charge free
electrolyte lead acid batteries used on petrol and diesel
engine vehicles, motor cycles, boats etc. and is suitable
for charging sealed batteries.
- Accumulators rechargeable in accordance to the output
voltage available: 6V / 3 cells, 12V / 6 cells.
- This model is a battery charger with a 100V-240V
50/60Hz single phase power supply, with electronically-
controlled constant current and voltage.
The charge current and voltage supplied by the
appliance follow the IU charge curve.
- Automatic detection of battery voltage (6V-12V).
- Standard equipment:
Cables with crocodile clips.
Cables tted with eyelets.
3. DESCRIPTION OF THE BATTERY CHARGER
Control, adjustment and signalling devices.
- The charging current is 0.75A:
- CHARGE LED “
”: charging in progress.
- FULL LED “
”: end of charging.
Attention: there is no polarity inversion
signal.
4. INSTALLATION
POSITIONING THE BATTERY CHARGER
- While the battery charger is in operation make sure it is
in a stable position.
- Do not lift the battery charger using the power supply
cable or the charge cable.
CONNECTIONTOPOWER
- The battery charger should be connected only and
exclusively to a power source with the neutral lead
connected to earth.
Check that the net voltage is the same as the voltage of
the equipment.
- Check that the power supply is protected by systems
as fuses or automatic switches, sufcient to support the
maximum absorption of welding.
- If you put an extension to the primary cable, the
diameter must be the same, never inferior.
- The connection to the power has to be made using the
cable.
5. OPERATION
BEFORE CHARGING
NB: Before charging check that the capacity of the
battery (Ah) which is to be charged, is not inferior to