User's Manual

ANTENNA CARE AND REPLACEMENT

Do not use the unit with a damaged antenna. If a damaged antenna comes into contact with the skin, a minor

burn may result. Have your antenna replaced by a qualified technician immediately. Use only a manufacturer-

approved antenna. Non-approved antennas, modifications, or attachments could impair service quality,

damage the Telguard and violate FCC regulations.

ELECTRONIC DEVICES

Most modern electronic equipment is shielded from RF energy. However, RF energy from cellular devices

may affect inadequately shielded electronic equipment. RF energy may affect improperly installed or

inadequately shielded electronic equipment operating in homes and businesses. Check with the manufacturer

or its representative to determine if these systems are adequately shielded from external RF energy. Consult

the manufacturer of any personal medical devices (such as pacemakers, hearing aids, etc.) to determine if

they are adequately shielded from external RF energy.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

BLASTING AREAS

To avoid interfering with blasting operations, turn OFF your unit when in a “blasting area” or in areas posted:

“Turn off two-way radio.” Construction crews often use remote control RF devices to set off explosives.

POTENTIALLY EXPLOSIVE ATMOSPHERES

Turn OFF your unit when in any area with a potentially explosive atmosphere. It is rare, but your Telguard

Digital or its accessories could generate sparks. Sparks in such areas could cause an explosion or fire

resulting in bodily injury or even death. Areas with a potentially explosive atmosphere are often, but not

always, clearly marked. They include fueling areas such as gas stations; below deck on boats; fuel or

chemical transfer or storage facilities; areas where the air contains chemicals or particles, such as grain, dust,

or metal powders; and any other area where you would normally be advised to turn off your vehicle engine.

Do not transport or store flammable gas, liquid or explosives in the area of your Telguard Digital or

accessories.

Vehicles using liquefied petroleum gas (such as propane or butane) must comply with the National Fire

Protection Standard (FPA-58). For a copy of this standard, contact the National Fire Protection Association,

One Batterymarch Park, Quincy, MA 02269, Attn: Publications Sales Division.