User's Manual

NOTE: SPECIAL LED INDICATIONS DURING ACTIVATION

IF THE TELGUARD FAILS THE REGISTRATION PROCESS IT WILL BE DISPLAYED ON THE LEDS.

1. IF LED #1 AND LED #4 ARE FLASHING, THE TELGUARD SERIAL NUMBER IS NOT IN THE DATABASE AT THE

TELULAR COMMUNICATION CENTER, CALL TECHNICAL SUPPORT TO VERIFY PROPER LINE RANGE.

2. IF ALL OF THE LEDS ARE FLASHING, THE REGISTRATION MESSAGE WAS NOT RECEIVED AT THE

TELULAR COMMUNICATION CENTER. RETRY TRANSMITTING REGISTRATION MESSAGE. IF TELGUARD

FAILS A SECOND TIME TO REGISTER, CHECK SIGNAL STRENGTH. IF SIGNAL STRENGTH IS OK, THEN

CALL TECHNICAL SUPPORT.

ON EITHER INDICATION OF FAILED REGISTRATION, THE UNIT MUST BE RESET

BY “SHORTING” J10 (RSSI

JUMPER) , THE REGISTRATION MESSAGE MUST BE RESENT

OR THE TELGUARD WILL TRANSMIT ALL

SIGNALS THROUGH THE TELCO CONNECTION.

SYSTEM STATUS LEDS REGISTRATION INDICATIONS

ALL LEDS FLASHING FAILED REGISTRATION – SIGNAL TOO WEAK

LED #1 & LED #4 FLASHING REGISTRATION ERROR – CALL TECHNICAL SUPPORT

LED #1 ON REGISTRATION SUCCESSFUL

LED #2 SOLID NOT REGISTERED NEED TO CONNECT PANEL AND TRIP ZONE

SYSTEM TROUBLE CONDITION, STC (LED #2)

STATUS LED #2 INDICATION

1 FLASH AC LOW/MISSING

2 FLASH LBC LOW BATTERY and/or BATTERY CHARGER FAIL

3 FLASH LFC LINE FAULT

4 FLASH NSC NO SERVICE

5 FLASH RFC RADIO FAILURE

6 FLASH DTF DIAL TONE FAIL

5.3.1 Setup & Programming the Operating Parameters in the Telguard

When the Telguard is received from the factory and is powered up for the first time, it is immediately ready for

registration, provided the default settings are what you want. The STC LED #2 will flash to indicate any failure

conditions. The Mode LED #3 will be on and the STC 1 and STC 2 relays will be tripped. If changes are

required to the default settings, the Telguard can be programmed using a line-mans butt-set connected to T &

R Test Points or a POTS phone connected to J7 (black connector where the C/C is normally connected).

5.3.1.1 Command Key Sequences for Pots Programming

Key Sequence Description

# * Enters the programming Mode

Exits programming and stores changes

TO PROGRAM THE TELGUARD

A. Put the line-mans butt-set in talk mode or pick up the POTS phone,

B. Connect power to the Telguard, when ready for programming you will hear 2 beeps

C. Press #, *, this will put the Telguard into a Master Access programming mode, 2 beep.

D. Enter changes required

The syntax for programming a specific memory location is as follows:

MEMORY LOCATION (3-digits), will respond with 2 beeps, then VALUE, will respond with 2

beeps.

E. Press *, you will hear 2 beeps then hang up. This saves the change and exits the

programming mode.