User's Manual

4.0 INSTALLATION SUMMARY

There are five steps in installing Telguard properly. IF YOU DO NOT PROCEED IN THE ORDER AND

MANNER PRESCRIBED, YOU MAY NOT COMPLETE THE INSTALLATION IN THE TIME ALLOCATED.

These five steps are summarized below and then explained in detail in the remainder of this manual.

4.1 REGISTER & ACTIVATE THE TELGUARD ON CELLULAR NETWORK

Complete the activation form online at www.telular.com or fax the activation form that is included with the product to

Telular Communication Center prior to leaving for the job site. Within 30 minutes of receipt of the activation request,

the subscriber record will be created and the Telguard will be ready for activation.

4.2 TRANSMIT C/C ALARMS OVER THE TELCO CONNECTION

Once you have confirmed that the unit is active, you will be ready to verify that the C/C is programmed properly.

This step is important to verify that the C/C is programmed with valid account code and central station information

before transmitting signals through the cellular network.

4.3 TRANSMIT C/C ALARMS OVER THE CELLULAR RADIO NETWORK

Next, you will be connecting the C/C's digital dialer output to Telguard and verifying that alarm signals can be

reliably sent through Telguard over cellular to the central station receiver. The incoming Telco line is not

connected to Telguard during this step. NOTE: the first alarm registers the Telguard with the Telular

Communication Center and will not be transmitted

to the Central Station. All signals after the first are

sent to the Central Station.

4.4 CONNECT SUPERVISORY TRIP OUTPUTS

Telguard's supervisory trip outputs are connected to the C/C and then tested.

4.5 COMPLETE THE INSTALLATION

Your last step will be to check the jumper setting of J10 (LED mode, open = normal), attach earth ground, and

permanently mount the unit.

* * * *

With this overview of the installation in mind, you should now proceed with the actual installation, following the

steps described in the remainder of this manual.

5.0 INSTALLATION STEPS

This five-step installation approach (5.1 through 5.5) provides the alarm installer with the easiest and fastest

method of properly installing Telguard. Please follow the instructions carefully and if you should need

assistance or have any questions, call Telular TECHNICAL SUPPORT at 1-800-229-2326 extension 9.

NOTE: Dealer Account Establishment and Cellular Activation must be complete prior to Installation

(see section 3.0)

5.1 STEP 1: ACTIVATE & REGISTER THE TELGUARD UNIT

5.1.1 Activate Cellular Service

Complete the activation form online at www.Telguard.com or Fax the activation form that is included

with the product to Telular Communication Center to activate cellular service. Registration takes place

Monday-Friday from 8:00AM to 8:00PM and Saturday 9:00AM to 5:00PM EST. Service registration

occurs within 30 minutes of receipt of the activation form. Activation occurs automatically upon

transmission of the first alarm signal.

5.1.2 Locate Unit

Pick a spot next to the C/C where you think the Telguard will be mounted and place the unit down

temporarily in that spot. Do not mount it permanently now, since it may need to be moved to

receive a better cellular radio signal or a remote high-gain antenna may be necessary.