User's Manual

ManualsBrandsTelular ManualsElectronicsResidential & Business Cellular Alarm Communicator

The following supervisory features or combination of features are programmable to trip the STC

relays in order to meet a variety of installation requirements:

• Trips on AC fail condition (ACFC)

• Trips on low or missing battery condition (LBC).

• Trips on line fault condition (LFC).

• Trips on no service condition (NSC).

• Trips on radio communication failure condition (RFC).

The following system trouble features are embedded in the Telguard for tripping the STC relay and

cannot be changed:

• Tripped when unit is not registered with the Telular Communications Center (TCC)

• Trips on catastrophic failure (CF) if all power is lost.

• Trips on transmit-disable command from the Communication Center. This radio command

disables only the Telguard transmitter and would be used, for example, to shut down the

Telguard due to a runaway dialer.

2.7 D

IAGNOSTIC AND STATUS LEDS

Six LEDs are provided as a useful aid during installation and give installers an immediate visual indication of

system status.

LED Function Table – Normal Operating Mode (J10 = OUT)

LED Symbol Color Duty Cycle Indication

LED #1

Green

Solid On Unit is registered with the message center and enabled

Registration Off Unit not registered with message center (and disabled)

Flashing Unit is registered but disabled

LED #2

Red

Off ALL OK

STC 1 Flash* System Trouble Condition – Low/Missing AC Power

(System Trouble

Condition)

2 Flashes* System Trouble Condition – LBC or Battery Charger Failure

3 Flashes* System Trouble Condition – LFC

4 Flashes* System Trouble Condition – NSC

5 Flashes* System Trouble Condition – RFC

6 Flashes* System Trouble Condition – DTF

LED #3

MODE

Yellow

Off Mode 2, Cell Priority

On Mode 1, Telco Priority

Fast Flash C/C off-hook to transmit signals over cellular.

LED #4

Acknowledgement

Red

Solid On Telguard waiting for acknowledgement from Communication

Center

Off Idle state

Flashing When flashing with LED #1 unit has failed registration due to

the programming of the panel, CALL TECH SUPPORT

LED #5

Radio

Green

Off TG-7 initialized

On TG-7 initializing & registering with cellular network or

Transmitting Alarm Data

Short Flash (1 sec) Radio receiving message

Long Flash (2 sec) Radio sending message

LED #6

AC Power

Red Solid On AC power connected to unit