User's Manual

Phonecell
®
SX6P GSM 3 User Manual
Battery Operation
The SX6P will recharge its battery pack when connected to AC power. If AC power is interrupted,
the SX6P will continue to operate, using power from the battery. The SX6P will not operate if the
battery pack is not installed even if it is connected to AC power.
Location and Setup
The SX6P comes with a standard spike antenna (TNC).
1. Attach and finger-tighten the antenna - see Figure 6. Do not over-tighten the antenna.
2. Select a location that is above ground and as close to windows (or exterior walls) as possible
to get the best signal - see Figure 7.
Connect the Handset
Before you can use the SX6P, you must connect the handset cable.
1. Connect the handset cable to the phone jack - see Figure 8.
2. Connect the handset cable to the handset - see Figure 8.
Insert
Mounting
Clip into
the Cradle
(tab up)
Mounting Clip in
Cradle (tab up)
Figure 12 – Handset mounting clip for wall-mount.
Remove
Mounting Clip
from the Cradle
(tab down)
Figure 11 – Handset mounting clip assembly.
Figure 14 – Mount the SX6P onto the screws.
83 mm (3-1/4 inches)
Figure 13 – SX6P mounting hooks.
Mounting
Holes