Manualshelf

User's Manual

ManualsBrandsTelular ManualsElectronicsPhoneCell SX5
21222324252627282930
Auto-Routing Setup (GSM to Extension)
The SX5e can be configured to automatically route an incoming call from the GSM network to an
extension in the PBX when in Extension Mode. Two steps are required to set this up after you
connect a DTMF telephone to the trunk side of the SX5e (marked with a telephone icon).
1. Enable auto-routing by pressing: #
*
109
*
0 #
2. Configure the extension to route to by pressing: #
*
110
*
<extension number> #
NOTE: The extension number can be up to 8 digits, between 0 through 9.
Example: Assume that the SX5e is connected to extension 123 of your PBX. To enable the SX5e
to automatically route all its GSM calls to another extension that goes to a specific person or
operator at extension 999, follow these instructions.
1. Make sure you are in Extension Mode by entering #
*
108
*
1 # from a DTMF phone con-
nected to the trunk side connector.
2. Enable Auto-Routing by pressing #
*
109
*
0 # from the same DTMF phone connected to
the trunk side connector.
3. Configure the auto-route extension (in this example, 999) by pressing #
*
110
*
999 #.
4. When the SX5e receives a call, it will automatically answer the call, then dial 999 on the
extension line. This means extension 123 is calling 999.
5. The far end caller (the person who called the SX5e) will hear the line answered, then will
hear whatever the PBX presents when calling an extension.
Two-Stage Extension Side Dialing (Extension to GSM)
When connected to a PBX extension, any other extension on the PBX can access the SX5e.
The SX5e will always present two-stage dialing where another extension can access the GSM
network (extension side least cost routing). Only Extension Mode setup is required. No other set-
tings need changing.
Example: The SX5e is connected to extension 123 on the PBX. To allow extension side dialing,
setup the unit for Extension Mode and call the unit.
1. Make sure you are in Extension Mode by entering #
*
108
*
1 # from a DTMF phone con-
nected to the trunk side connector.
2. Call extension 123 from another PBX extension (or from the trunk side of the PBX).
3. When called, the SX5e will automatically answer, then present a dial tone.
4. Once a dial tone is heard, you may dial a number. The connection will be over the GSM network.
Phonecell
®
SX5e GSM 23 User Manual