User's Manual

Example: Assume that your SX5e is connected to a PBX on extension 123. Now assume that you
want to be able to connect to any extension (i.e. 858) when you call the SX5e on the GSM network.
1. Make sure you are in Extension Mode by entering #
*
108
*
1 # from a DTMF phone
connected to the trunk side connector.
2. Enable Two-Stage Dialing by pressing #
*
109
*
1 # from the same DTMF phone connected
to the trunk side connector.
3. When the SX5e receives a call, it will automatically answer the call, then present a dial tone.
4. When you hear a dial tone, enter the extension you wish to call (858).
5. The far end caller (the person who called the SX5e) will hear whatever the PBX presents
after you dialed the extension number.
Phonecell
®
SX5e GSM 22 User Manual
PBX Command Summary
Mode/Option Command Result
Change to Trunk Mode #
*
108
*
2 # Enables the SX5e Trunk Mode.
Note: This is the default mode
for the SX5e PBX option.
Change to Extension Mode #
*
108
*
1 # Enables the SX5e Extension
Mode.
Enable Auto-Route #
*
109
*
0 # Enables the SX5e to Auto-Route
to an extension when in Extension
Mode. Incoming calls to the SX5e
will be routed to the Auto-Route
Extension Number automatically.
This setting disables two-stage
dialing.
Auto-Route Extension #
*
110
*
<extension> # Sets the extension number that
Number will be called when Auto-Route
is enabled.
Enable Two-Stage Dialing #
*
109
*
1 # Disables Auto-Route and enables
two-stage dialing. Callers will be
able to dial any extension within
the PBX. This is the default mode.
Enable Disconnect Tone #
*
111
*
<dtmf> # Enables the detection of <dtmf>
Detection DTMF 0 through 9 = 1 through 10 for disconnection by the PBX.
DTMF
*
= 11
DTMF # = 12
DTMF A = 13
DTMF B = 14
DTMF C = 15
DTMF D = 16
Disable Disconnect Tone #
*
111
*
0 # Disables the detection of a DTMF
Detection tone for disconnection by the PBX.
This is the default mode