User's Manual

Phonecell
®
SX5e GSM 19 User Manual
SX5e GSM FWT WITH FAX
The SX5e GSM FWT with Fax allows connection to a fax machine and additional telephones.
The SX5e can be set up to use one or both of its phone jacks. In Single Jack mode, only the
jack designated with a telephone icon is operational. You can connect a fax machine or an addi-
tional telephone into that jack, but to receive faxes you must have a fax machine connected. In
Dual Jack mode, the unmarked jack is used for fax, and the jack marked with the telephone icon
is used for any additional phones.
Set SX5e for Analog Fax
Set In-Bound Fax Port Option
Press: #
*
67
*
<fax_port> #
1 = send incoming fax calls to RJ-11
jack (default).
3 = send incoming fax calls to the seri-
al port.
Set Single/Dual Jack Mode
Press: #
*
63
*
<single jack> #
0 = single jack
1 = dual jack (default)
Connect SX5e for Dual Jack Mode
1. Connect a fax machine to the unmarked
phone jack on the SX5e - see Figure 12.
2. Connect a regular phone to the phone
jack that is marked with a telephone icon.
Connect SX5e for Single Jack Mode
1. Connect a fax machine to the phone jack on the SX5e that is marked with a telephone
icon - see Figure 13.
NOTE: The fax by-pass must be entered to send a fax in single jack mode because the
SX5e default setting is for voice calls.
Analog Fax Bypass
This feature allows the phone jack to process the next outgoing call as an analog fax call. After
this call, the phone jack automatically returns to the default voice protocol. The user enters this
key sequence prior to dialing the telephone number. The terminal interprets the string and prop-
erly sets up the call. Refer to the following examples.
NOTE: The analog fax bypass string can only be used in single jack operation.
Use the Fax Bypass
1. Lift up the handset (take off-hook).
2. Press: #
*
19
*
1 #, then dial the fax number to be called.
3. Press START on the fax machine.
HINT: If the fax machine does not have a handset, enter #
*
19
*
1 #, followed by the
remote fax number to be called. Press START.
HINT: If the fax machine has the capability to store telephone numbers for speed dialing, the
#
*
19
*
1 # command string may be programmed into the machine as a prefix to the telephone
number. With some machines, it may also be possible to store the command string as a speed
dial number and dial the remote fax machine telephone number manually.
Figure 12 - Dual Jack mode connections.
Figure 13 - Single Jack mode connection.