User's Manual

Single Jack Setup
This feature allows both the fax machine and extension phones to use the same RJ-11 jack on
the SX5D (as in the case of combination fax/phones). Connect a fax machine to the phone jack
on the SX5D that is marked with a telephone icon - see Figure 25.
1. Press the MENU key.
2. Select Settings, then select Fax Settings.
3. Select Analog Fax Jack.
4. Select Single Jack.
Analog Fax Bypass
In single jack mode, the SX5D default is for voice calls, so a fax by-pass must be entered to
send faxes. After a fax is sent, the SX5D will automatically reset itself for voice calls.
1. Lift up the handset (take off-hook).
2. Press: #
*
19
*
1 #, then dial the fax number to be called.
3. Press START on the fax machine.
HINT: If the fax machine does not have a handset, enter #
*
19
*
1 #, followed by the
remote fax number to be called. Press START.
Routing Faxes to the Serial Port
1. Press the MENU key.
2. Select Settings, then select Fax Settings.
3. Select Port, then select Serial Port.
NOTE: The SX5D must be connected to a computer, or other device that is set up for digital
data, via the serial connector in order to send or receive digital faxes.
Phonecell
®
SX5D GSM 34 User Manual
Figure 25 - Connect the SX5D for single jack mode.
This RJ-11 Jack
is not usable.
RJ-11 Cable
OR