User's Manual
56020801
Pag
e
© 2000 Telular Corporation
iv
P
ART
68
This equipment complies with Part 68 of the FCC Rules. Located on the inside of the hinged door of
Telguard
models
T200C001 and T300C001 is a label that contains, among other information, the FCC Registration Number and Ringer
Equivalence Number (REN) for this equipment. If requested, this information must be provided to the Telephone Company.
The
Telguard
Cellular Alarm Transmission System
is registered for connection to the public telephone
network using an RJ38X or RJ31X jack. When selecting a mounting location, do not mount this unit in an area
where the general public could reasonably be within 20cm (8 inches) of the antenna.
The ringer equivalence number (REN) is used to determine the quantity of devices which may be connected
to the telephone line. Excessive REN's on the telephone line may result in the devices not ringing in response
to an incoming call. In most, but not all areas, the sum of the REN's should not exceed five (5.0). To be
certain of the number of devices that may be connected to the line, as determined by the total number of
REN's, contact the telephone company to determine the maximum of REN for the calling area.
If the
Telguard
Cellular Alarm Transmission System
caused harm to the telephone network, the Telephone
Company will notify you in advance that temporary discontinuance of the service may be required. But if
advance notice is not practical, the Telephone Company will notify the customer as soon as possible. Also,
you will be advised of your rights to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in it's facilities, equipment, operation, or procedures that could
affect the operation of the equipment. If this happens, the Telephone Company will provide advance notice in
order for you to make the necessary modifications in order to maintain uninterrupted service. If trouble is
experienced with the
Telguard
Cellular Alarm Transmission System
please contact Telular Technical
Service in the U.S.A. for repair and (or) warranty information.
Telular Security Products
T
ECHNICAL
S
ERVICES
D
EPARTMENT
420 Thornton Road, Suite 109
Lithia Springs, GA 30122
Phone: (800) 229-2326
If the trouble is causing harm to the telephone network, the Telephone Company may request that you remove the equipment
from the network until the problem is resolved.
The customer (user) should not attempt any repair to
the Telguard
Cellular Alarm Transmission System
.
Repair of this equipment should be referred to only qualified technical personnel.
Note that this equipment cannot be used on the public coin service provided by the Telephone Company.
Connection to Party Line Service is subject to state tariffs.
(Contact the state public utility commission or
corporation commission for information).
FUTURE TESTING AND LIMITATIONS ON USE
Telguard
is part of an advanced design alarm-communication system. It does not offer guaranteed protection against
burglary and fire. Any alarm communication system is subject to compromise or failure.
The Telguard
will not work without power. Devices powered by AC will not work if the AC power supply is off
for any reason, however briefly, and at the same time, the backup battery is missing, dead or not properly installed.
The cellular radio network, needed to transmit alarm signals from a protected premises to a central monitoring station,
may be inoperable or temporarily out of service. Cellular radio networks are also subject to compromise by
sophisticated methods of attack.