User's Manual

56020801
Pag
e
© 2000 Telular Corporation
ii
NOTICES
A
BOUT THIS
M
ANUAL
This manual assumes that you have basic security system installation skills such as measuring
voltages, stripping wire, properly connecting wires together, connecting wires to terminals, and
checking phone lines. It also assumes that you have a familiarity with the proper installation and
programming tasks related to various Control/Communicator panels.
The material and instructions covered in this manual have been carefully checked for accuracy and
are presumed to be reliable. However, Telular assumes no responsibility for inaccuracies and
reserves the right to modify and revise this manual without notice.
It is our goal at Telular to always supply accurate and reliable documentation. If a discrepancy is
found in this documentation, please mail or fax a photocopy of the corrected material to:
Telular Security Products
Technical Services Department
420 Thornton Road, Suite 109
Lithia Springs, GA 30122
Fax: [phone]
© 2000 Telular Corporation. Lithia Springs, GA U.S.A. All rights reserved.
FCC Notices
E
XPOSURE TO
R
ADIO
F
REQUENCY
E
NERGY
In 1991, the Institute of Electrical and Electronics Engineers (IEEE), and in 1992, the American National
Standards Institute (ANSI), updated the 1982 ANSI Standard for safety levels with respect to human exposure
to RF energy. Over 120 scientists, engineers and physicians from universities, government health agencies
and industry, after reviewing the available body of research, developed this updated Standard. In March,
1993, the U.S. Federal Communications Commission (FCC) proposed the adoption of this updated Standard.
The design of your Telular
Telguard DataBurst
complies with this updated Standard. Of course, if you
want to limit RF exposure even further than the updated ANSI Standard, you may choose to install the unit in
a manner that locates its antenna at an even greater distance from the general public than is recommended as a
minimum by the standard.
To insure compliance with the standard, when selecting a mounting location for your
Telguard DataBurst
do
not mount it (or its associated antenna) in an area where the general public could reasonably be within 8
inches (20 centimeters) of the antenna.
E
FFICIENT
O
PERATION
Do not operate your Telular product when holding the antenna. Be sure to mount the unit such that its antenna is a minimum of
eight (8) inches (20 centimeters) is maintained from the general public.
For the best service quality, keep the antenna free from obstructions and point the antenna straight up.
A
NTENNA
C
ARE AND
R
EPLACEMENT
Do not use the unit with a damaged antenna. If a damaged antenna comes into contact with the skin, a minor
burn may result. Have your antenna replaced by a qualified technician immediately. Use only a manufacturer-
approved antenna. Non-approved antennas, modifications, or attachments could impair service quality,
damage the Telguard and violate FCC regulations.