User's Manual

56020801
Pag
e
© 2000 Telular Corporation
10
5.2
S
TEP
2:
P
ROGRAM
T
ELGUARD AND
C
ONFIRM
C
OMMUNICATIONS
I
NTEGRITY
Confirm that Telguard's programming parameters are correctly entered into the unit, cellular service is activated, and
Telguard has adequate cellular signal-strength.
This is the most important step in the installation, since the
programming parameters contain all the necessary information for successful communications and good signal-
strength insures performance reliability.
5.2.1 Locate Unit
Pick a spot next to the C/C where you think the Telguard will be mounted and place the unit down
temporarily in that spot.
Do not mount it permanently now
, since it may need to be moved to
receive a better cellular radio signal or a remote high-gain antenna may be necessary.
TG3 Step 02.VSD
HOST C/C
24 HOUR ZONE COMMON
24 HOUR ZONE INPUT
TELCO DIALER
DETAILS ON JACK AND PIN ASSIGNMENTS,
TERMINAL STRIP, JUMPER, AND STATUS LEDS.
SEE APPENDICES A1.1 THROUGH A1.4 FOR
J2
FUSE 3A 3AG
SIGNAL
STRENGTH
LEDS
STATUS LEDS
(See Appendix A1.3)
T
R
1
23456
STC (COM)
STC (N.O.)
+ BATTERY 12V
- BATTERY
7
AC (16.5V 40VA)
AC (16.5V 40VA)
BLANK PIN
J1
TO PROGRAM UNIT:
USE BUTTSET CONNECTED TO T AND R
TEST PINS OR USE TOUCHTONE
TELEPHONE PLUGGED DIRECTLY INTO J2.
EARTH G ROUND
R
AC POWER
SYSTEM TROUBLE
RADIO TX
OPERATION MODE
ANTENNA
TRANSCEIVER
RJ31X
PREMISE
PHONES
INCOMING
TELCO
TELGUARD
LED MODE SELECT
J5
IN = RSSI
OUT = NORMAL