User's Manual

56019201
Pag
e
© 2000 Telular Corporation
ii
E
FFICIENT
O
PERATION
Do not operate your Telular product when holding the antenna. Be sure to mount the unit such that its antenna is a minimum of
eight (8) inches (20 centimeters) is maintained from the general public.
For the best service quality, keep the antenna free from obstructions and point the antenna straight up.
A
NTENNA
C
ARE AND
R
EPLACEMENT
Do not use the unit with a damaged antenna. If a damaged antenna comes into contact with the skin, a minor
burn may result. Have your antenna replaced by a qualified technician immediately. Use only a manufacturer-
approved antenna. Non-approved antennas, modifications, or attachments could impair service quality,
damage the Telguard and violate FCC regulations.
E
LECTRONIC
D
EVICES
Most modern electronic equipment is shielded from RF energy. However, RF energy from cellular devices
may affect inadequately shielded electronic equipment.
RF energy may affect improperly installed or inadequately shielded electronic equipment operating in homes
and businesses. Check with the manufacturer or its representative to determine if these systems are
adequately shielded from external RF energy.
Consult the manufacturer of any personal medical devices (such as pacemakers, hearing aids, etc.) to
determine if they are adequately shielded from external RF energy.
B
LASTING
A
REAS
To avoid interfering with blasting operations, turn OFF your unit when in a “blasting area” or in areas
posted: “Turn off two-way radio.” Construction crews often use remote control RF devices to set off
explosives.
P
OTENTIALLY
E
XPLOSIVE
A
TMOSPHERES
Turn OFF your unit when in any area with a potentially explosive atmosphere. It is rare, but your
Telguard
DataBurst
or its accessories could generate sparks. Sparks in such areas could cause an explosion or fire
resulting in bodily injury or even death.
Areas with a potentially explosive atmosphere are often, but not always, clearly marked. They include
fueling areas such as gas stations; below deck on boats; fuel or chemical transfer or storage facilities; areas
where the air contains chemicals or particles, such as grain, dust, or metal powders; and any other area
where you would normally be advised to turn off your vehicle engine.
Do not transport or store flammable gas, liquid or explosives in the area of your
Telguard DataBurst
or
accessories.
Vehicles using liquefied petroleum gas (such as propane or butane) must comply with the National Fire
Protection Standard (FPA-58). For a copy of this standard, contact the National Fire Protection Association,
One Batterymarch Park, Quincy, MA 02269, Attn: Publications Sales Division.
--------------------------------------------------------------------------------
FCC P
ART
15 C
LASS
B C
OMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital computing device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment OFF and ON, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the radio/television antenna.
•
Increase the separation between the radio/television equipment and the Telguard terminal.