User's Manual

Phonecell SX4P TDMA 800 9 User Manual
be displayed.
3) To dial a missed call, press the Redial/Hands-Free key when the missed call number is dis-
played. Lift the handset when the call is connected.
4) To exit, go off-hook or do nothing for 2 minutes.
View Dialed Calls
The SX4P will store a maximum of 10 dialed calls.
1) The SX4P must be on-hook to view dialed calls. If the SX4P is off-hook or no key entry is
made within two minutes, the operation will terminate.
2) Press the Down key. DIALED CALLS will be displayed in the Indicator (bottom) row.
3) Press the Up/Down keys to scroll through all dialed calls. Dialed telephone numbers will be
displayed in the Indicator (bottom) row.
5) To dial a call, press the Redial/Hands-Free key when that dialed call number is displayed. Lift
the handset when the call is connected.
6) To exit, go off-hook or do nothing for two minutes.
Hookflash
When you initiate the Hookflash function, it automatically lets you:
• Speed up the connection after you dial a phone number.
• Answer an incoming call that occurs when you’re dialing a phone number.
• Use special (supplementary) cellular services which may be available in your cellular service area.
Use the Hookflash Function
There are two ways to initiate the Hookflash function:
• Press the Flash key on your SX4P OR
• Press the hang up or switch-hook mechanism on your SX4P once quickly (approximately 1/2-second).
IMPORTANT TONES AND ALERTS
No-Service Tone
When cellular service is not available, the receiver emits a No-Service (fast-beeping) tone
instead of the normal (steady) dial tone.
ROH (Receiver Off-Hook) Tone
If the SX4P handset remains off-hook (off its cradle) with no dialing activity for 30 seconds, the
receiver emits an ROH tone for 45 seconds.
Incoming Call Alert
If you’re dialing a number and an incoming call occurs, the receiver will emit an audible ring. To
answer the incoming call:
• Press the Flash button once. This will connect the incoming call OR
• Hang-up immediately. This will cause the phone to start ringing.
Roam Dial Tone
When cellular service is available, but the SX4P is in a Roam area, the receiver may emit a dif-
ferent dial tone to indicate the roaming condition. However, unless the SX4P is re-programmed
in the field, the factory default tone is set the same as normal service dial tone.
Variable Dial Time (Auto Send Delay) Option
When you place a call, your SX4P automatically sends the phone number over the cellular net-
work after you dial the last digit. However, to make sure you have enough time to dial the last
digit, a 3-second Auto SEND Delay is programmed into the unit at the factory. To change the
Auto SEND Delay setting, see the User Programming Commands section of this manual.
Zero Dial Delay for Frequently Called Numbers
A new patented feature enables the Phonecell SX4P to recognize your frequently called phone
numbers and send them immediately – without the 3-second Auto Send Delay. The SX4P stores
a list of up to 50 different numbers in its memory. This list contains the last 50 numbers that have
been called at least twice successfully.
NOTE: Cycling (turning OFF/ON) the power will erase the current list. A new list will be started
when power is re-applied. To enable or disable this feature, see the User Set-Up Commands
section of this manual.