User's Manual

Connect the Phonecell SX4P to AC Power
1) Turn the AC/Battery Switch to the AC position - see Figure 5.
2) Connect the barrel connector of the power supply to the rear panel receptacle of the
SX4P - see Figure 5.
3) Plug the power supply into the AC socket. The unit will power up automatically.
4) Check the cellular signal strength and move the unit until you achieve the best signal
possible - see the Received Signal Strength section of this manual.
Optional Wall-Mount Instructions
1) Remove the mounting clip from the cradle and re-insert it with the tab pointing up - see
Figures 6 and 7.
2) Mark two hole locations 83 mm (3-1/4 inches) vertically apart and drill two holes into the wall.
3) Install the screws (not supplied) into the wall, leaving a gap (approximately 3 mm (1/8 inches))
between the screw head and the wall.
4) Align the mounting holes with the screws and mount the SX4P onto the screws - see
Figures 8 and 9.
Phonecell SX4P TDMA 800 5 User Manual
Figure 9 – Mount the SX4P onto the screws.
83 mm (3-1/4 inches)
Figure 8 – SX4P mounting hooks.
Mounting
Holes
Insert
Mounting
Clip into
the Cradle
(tab up)
Mounting
Clip in
Cradle
(tab up)
Figure 7 – Handset mounting clip assembly for
wall-mount applications.
Remove
Mounting Clip
from the Cradle
(tab down)
Figure 6 – Handset
mounting clip assembly.
AC
Power
Figure 5 – Location of the SX4P’s AC power input and AC/Battery switch.
AC/Battery
Switch
AC Power Input
AC
Position
Battery
Position
Barrel
Connector