User's Manual

Code: D148X01PT_DDS06
MBS USER AND
INSTALLATION
MANUAL
Date: 19-Dec-2012 Page: 17 of 36
01.01.00/1 Rev.1
Steps to install a MBS on a mast/pole:
1) Place the MBS Unit bracket on the mast/pole as follows.
Note: Handle the MBS Unit bracket with care if it rests on the floor. Place some
protection underneath to prevent scratches on the surface.
a) Secure 4 holes clamps on the bracket by tightening the bolts with a 15 Nm
torque, using a 17 mm torque wrench, do not forget to place the washers
b) Install the bracket to the desired final location on the mast/pole. Embrace the 2
holes clamps and screw these to the bracket with a 17 mm wrench and 15 Nm
torque. Due to the length of the bolts it is advisable to screw them slowly.