User's Manual

MBS USER AND
INSTALLATION
MANUAL
Code: D148X01PT_DDS06
Date: 14-Nov-2014 Page: 5 of 41
01.01.00/1 Rev.1
4. LABELLING AND INFORMATION ON SAFETY AND ELECTROMAGNETIC
COMPATIBILITY
The equipment is supplied with an identification label where the model, the IC
Certificate number and the FCC ID are displayed depending on the frequency work band.
The equipment has been designed to fulfil the applicable compliance regulations.
The equipment complies with the applicable Parts of the FCC Title 47 of the Code of
Federal Regulations and Industry Canada (IC) RSS-119 Standard.
This device complies with part 15 of the FCC Rules and Industry Canada ICES-003.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
RF Exposure Requirements:
CAUTION:
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Antennas used for this transmitter must not exceed an antenna gain of 20 dBi and
be located at least 400 cm, away from any person(s) in order to comply with the FCC and
IC RF exposure requirements.
Failure to observe these restrictions will result in exceeding the RF exposure limits.