User's Manual

MBS USER AND
INSTALLATION
MANUAL
Code: D148X01PT_DDS06
Date: 14-Nov-2014 Page: 25 of 41
01.01.00/1 Rev.1
6.3.2. WALL INSTALLATION
To install the MBS Unit on a wall, make the following steps:
1) Mark the position of the holes using the bracket as a template itself with the help of a
level.
Note: To ensure proper ventilation there must be at least 700 mm clearance above
and below each MBS Unit. There must also be a minimum distance of 300 mm free
on both sides of the MBS Unit.
Note: The screws, expansion bolts and washers needed to secure the brackets to
wall are not supplied with the unit.
The distance between the holes are shown in the following figure.
2) Drill holes on the wall and insert a rawlplug in each hole.