User's Manual

MBS USER AND
INSTALLATION
MANUAL
Code: D148X01PT_DDS06
Date: 14-Nov-2014 Page: 21 of 41
01.01.00/1 Rev.1
The brackets should be installed tight enough to support the MBS Unit without causing
deformation of the mast/pole or areas of corrosion.
Once mounted in its definitive location, if the vandal resistant kit is available, it will
prevent the access / disassembly not authorized.
In case of installing more than one MBS Unit on the same mast/pole, it is recommended
not to mount one above the other one to avoid the heat transfer from the MBS Unit low
to the MBS Unit high. If the MBS Units have to be installed in the same vertical axis
these must be oriented in different directions to increase the separation of them as far as
possible, depending on the length of wiring between both equipments (1.5 m
approximately).