User's Manual

MBS USER AND
INSTALLATION
MANUAL
Code: D148X01PT_DDS06
Date: 14-Nov-2014 Page: 18 of 41
01.01.00/1 Rev.1
6.2.BASIC PRE-CONFIGURATION
Before connecting the MBS Unit to the infrastructure it should have the IP address
correctly configured in order to have remote access once it is connected (to set the IP
address, see the configuration chapter (F067220) in technical manual).
Steps:
· Apply power supply to the MBS through its POWER_IN connector.
· Wait 3 minutes until the MBS Unit initializes.
· Connect the PC, to set the IP address, to the ETH connector.
· Change the IP address according to the network IP addressing.
· Check that IP address was successfully changed through a “ping” from the PC to the
new IP address of the MBS Unit.