User's Manual

User Manual

5 FIRST STEPS

5.1 Start-up

In the case of the DT-410, switch on the equipment with the main switch at the back of the

device.

1. Keep the key pressed to switch the equipment on or off.

2. On starting-up, it will display a welcome message (which can be configured by

programming). The software version of the equipment and the user’s name and address

will also be displayed for a few seconds.

3. If the equipment requests a PIN, enter the 4-digit code (by default the code is 0000),

which will appear on screen as ****, and press OK. It is recommended to change this

code for a safer one that you are able to remember.

4. If the user does not enter a correct PIN code after a number of permitted tries (which can

be configured, 3 attempts by default), the equipment will be locked until the personal

unlocking code - PUK - is entered (a 10-digit code). This code is provided by your

Service Provider.

5. When switching off the equipment, it will display a switch-off message and an acoustic

warning.

In the case of the DT-410, once the equipment has switched off completely at the front, you

can proceed to turn off the main switch at the rear.