User's Manual

Note: Your radio cannot be programmed when Connector Protector on
page122 is enabled.
To program a single radio
A data/programming cable, with either an RS232 (D-type) connector or a USB
connector, is available from PowerTrunk for customising a single radio.
A data/programming cable, with either an RS232 (D-type) connector or a USB
connector, is available from PowerTrunk for customising a single radio.
1. Connect the USBprogramming cable to the computer.
2.
Connect the cable to the radio by inserting the hook on the connector into
the slot as shown.
3.
Secure the cable in position. Do not over tighten.
4. When programming is complete disconnect the cable from the radio.
Revert radio settings to customisation settings
Users have the ability to add personal data to the radio, such as adding
contacts to the phonebook, changing the talkgroups and sending and
144
HTT-500-2 – 04/2017